Optimization and validation of an extraction method and HPAEC-PAD for determination of residual sugar composition in l-lactic acid industrial fermentation broth with a high salt content
Analytical Methods Pub Date: 2015-09-15 DOI: 10.1039/C5AY01703C
Abstract
In the production of L-lactic acid, the residual sugar in fermentation broth would lead to increased sugar content in its commercial products, bringing about lactic acid deterioration because of Maillard reactions and thus shortening their shelf life. In this work, the residual sugar components in L-lactic acid industrial fermentation broth with agricultural biomass-derived sugar were determined by means of high-performance anion-exchange chromatography (HPAEC) coupled with pulsed amperometric detection (PAD). A feasible off-line sample clean-up procedure consisting of sodium oxalate extraction, ethanol extraction and ion-exchange column extraction was developed to remove calcium ions, proteins, anion acids and organic acids before analysis, and their removal efficiencies were 100, 98.74, 97.99 and 99.41%, respectively. Under the optimized analytical conditions, the seventeen sugars, including four monosaccharides, eight disaccharides and five oligosaccharides, have been completely separated in one experimental run on a Dionex Carbopac PA 200 column with sodium hydroxide and sodium acetate as eluents. The method was validated, with good linearity (R2 > 0.99), high precision (RSDs < 5.47%), and sensitive detection limits (0.35–44.61 μg L?1); recoveries were >86.95% for short chain carbohydrates (degree of polymerization, DP < 4), while recoveries ranged from 81.87 to 61.41% for DP4 to DP7. The method was successfully applied for analysis of the residual sugar in lactic acid broth with a salt content as high as 120 g L?1 calcium lactate, using different kinds of starch (corn starch, corn flour and cassava starch) hydrolysates as carbon sources. Isomaltose (47.97–60.43%), sucrose (17.50–29.73%) and trehalose (3.05–7.51%) were the main components of residual sugar in these broths.
Recommended Literature
- [1] Evidence of rutile-to-anatase photo-induced electron transfer in mixed-phase TiO2 by solid-state NMR spectroscopy? Weili Dai,Guangjun Wu,Michael HungerChem. Commun., 2015,51, 13779-13782 10.1039/C5CC04971G
- [2] Excellent kinetics of single-phase Gd-doped ceria fuel electrodes in solid oxide cells? Andreas Nenning,Manuel Holzmann,Jürgen Fleig,Alexander K. OpitzMater. Adv., 2021,2, 5422-5431 10.1039/D1MA00202C
- [3] Emergence of microfluidic wearable technologies Joo Chuan Yeo,KenryLab Chip, 2016,16, 4082-4090 10.1039/C6LC00926C
- [4] Emulsion soft templating of carbide-derived carbon nanospheres with controllable porosity for capacitive electrochemical energy storage? M. Zeiger,N. J?ckel,P. Strubel,L. Borchardt,R. Reinhold,W. Nickel,J. Eckert,V. Presser,S. KaskelJ. Mater. Chem. A, 2015,3, 17983-17990 10.1039/C5TA03730A
- [5] Enabling non-flammable Li-metal batteries via electrolyte functionalization and interface engineering? Jing Yu,Yu-Qi Lyu,Jiapeng Liu,Mohammed B. Effat,Junxiong WuJ. Mater. Chem. A, 2019,7, 17995-18002 10.1039/C9TA03784E
- [6] Excited state potential energy surfaces and their interactions in FeIVO active sites Shaun D. Wong,Edward I. SolomonDalton Trans., 2014,43, 17567-17577 10.1039/C4DT01366B
- [7] Establishing the accuracy of position-specific carbon isotope analysis of propane by GC-pyrolysis-GC-IRMS ChangjieLiu,PengLiu,XiaofengWang,XiaoqiangLi,JuskeHorita 10.1002/rcm.9494
- [8] Excimer–monomer switch: a reaction-based approach for selective detection of fluoride? Qiao Song,Angela Bamesberger,Lingyun Yang,Haley Houtwed,Haishi CaoAnalyst, 2014,139, 3588-3592 10.1039/C4AN00522H
- [9] Empowering microfluidics by micro-3D printing and solution-based mineral coating? Hongxia Li,Aikifa Raza,Qiaoyu Ge,Jin-You Lu,TieJun ZhangSoft Matter, 2020,16, 6841-6849 10.1039/D0SM00958J
- [10] Excimer emission and magnetoluminescence of radical-based zinc(ii) complexes doped in host crystals? Shojiro Kimura,Tetsuro KusamotoChem. Commun., 2020,56, 11195-11198 10.1039/D0CC04830E
Journal Name:Analytical Methods
research_products
-
CAS no.: 89640-58-4