Connecting single-ion magnets through ligand dimerisation?

Dalton Transactions Pub Date: 2012-08-03 DOI: 10.1039/C2DT31226C

Abstract

A mononuclear as well as dinuclear DyIII complexes of general formula [Dy(hmb)(NO3)2(DMF)2] (1) and [Dy2(hmt)(NO3)4(DMF)4]·DMF (2), where Hhmb: (N′-(2-hydroxy-3-methoxybenzylidene)benzohydrazide and H2hmt: (N1,N4)-N′1,N′4-bis(2-hydroxy-3-methoxybenzylidene)terephthalohydrazide were obtained using a synthetic strategy involving a polytopic Schiff base ligand. Single-crystal X-ray analysis reveals the DyIII ion is in a distorted pentagonal interpenetrating tetrahedral arrangement. The two symmetrical DyIII ions in complex 2 exhibit the same geometry and are well-isolated in the molecule by an hmt2? ligand. The direct current (dc) and alternating current (ac) magnetic measurements of the compounds were investigated. Complex 1 did not exhibit any ac signal whereas a frequency dependant signal was observed for 2 under zero dc field. When an optimum dc field was applied, clear frequency dependant signals were obtained for both complexes indicative of Single-Ion Magnet behaviour with relaxation barriers of Ueff = 34 and 42 K for 1 and 2, respectively.

Graphical abstract: Connecting single-ion magnets through ligand dimerisation
Recommended Literature